东莞市大旺节能科技有限公司

JW101水性胶输送机(容量五公升）

JW101Water based giue converyer(capacity 5 litre)

本机热点：

一. 本机适用于刷水性胶

二. 采用不锈钢材质避免腐蚀，配备胶量可视管准备控制加胶时间。无内桶装置，胶水可全部用完不剩。

三. 密封式设计，可有效防止防水：

1表层凝固，浓度变高。

2. 涂布性不佳，胶太厚造成浪费。

3. 黏度升高，胶水变质，影响拉力。

四．可能约8%水性胶用量，有效改善工作环境之空气质量，维护工作人员健康。

五．不需经粘胶过程，可提高8%以上之工作效率，在操作中有充分的自我检视时间。 

注意事项：

一．打开机盖前一定要先泄压。

二．供氧之氧管内不可有水氧存在，以免造成压力桶内胶水变质，氧气必须维持在4kgc㎡左右。

三．下班时应将出胶口关门及进气口关门开关

四．保持压力桶管道清洁，停止使用48小时以上时，应先将机器清洗干净，连续使用一个月时，应将机器清洗干净一次，以免造成管道堵塞。

Features:

一．This machine is suitable for brushing water-based adhesive

二． Stainless steel material shall be used to avoid corrosion, and visual tube for glue quantity shall be equipped to control glue adding time. No inner barrel device, glue can be used up.

三 sealed design can effectively prevent water-proof:

1. The surface solidifies and the concentration becomes higher.

2. Poor coating performance, too thick glue causing waste.

3. The viscosity increases and the glue deteriorates, affecting the tensile force.

3. About 8% of the water-based glue may be used to effectively improve the air quality of the working environment and maintain the health of the staff.

四.It can improve the working efficiency by more than 8% without glue process, and has sufficient self inspection time in operation.

 Notices:

I. make sure to release the pressure before opening the cover.

2. There shall be no water or oxygen in the oxygen supply pipe, so as to avoid the deterioration of the glue in the pressure barrel. The oxygen must be maintained at about 4kgc ㎡.

3. close the rubber outlet and air inlet at the time of off duty

4. keep the pipeline of pressure barrel clean. When it is not used for more than 48 hours, clean the machine first. When it is used continuously for one month, clean the machine once to avoid blocking the pipeline.